Electrical Engineering Questions, Problems & Solutions : TransWikia.com ~ Page 61

Magnitude calculation of filter

I am working on a problem for a given transfer function given below and am having trouble calculating the magnitude and phase of it. The problem is specifically that I...

Asked on 12/05/2020 by smake5730

3 answer

What is the "positive charge" on a capacitor if only electrons and not protons flow through a circuit?

Speaking in non-conventional current terminology, electrons should build up from the positive terminal of power supply to the top plate of a capacitor. What I don't get is, from an...

Asked on 12/05/2020 by Mahmoud Maarouf

2 answer

Calculating the Running Corrleation of two signals in Matlab

I am currently using https://www.eecs.umich.edu/courses/eecs206/public/lab/ to advance my matlab skills. Sadly I am stuck at lab2 task 2. First, i cant run the pcode file to get...

Asked on 12/05/2020

0 answer

AVRDUDE does not recognize USBasp device

I'm am having issues with my USBasp programmer (Windows 10). I installed the WinUSB driver using zadig 2.4. When I run AVR dude with the following parametersavrdude -c...

Asked on 12/05/2020 by bas

3 answer

Adding switch gives an error in Proteus

This is the working circuit : I have researched it quite a lot in the past few hours but still I don't understand...

Asked on 12/04/2020 by Sizu Taylorventuresllc

2 answer

Keithley 2450 Charge/Discharge adjusting appropiate V and I

I'm using Keithley 2450 model for charging/discharging battery. My aim is to find charge/discharge characteristics of 100mAH 9V battery. In the following link, they have described discharge characteristics of 2300mAH...

Asked on 12/04/2020 by esilik

1 answer

Is it possible to use internal pullups on SAMD21 when pins are configured for SERCOM (SPI) mode?

According to the datasheet screen clip shown below, the internal pull up/dn configured in the PORT registers is still supposed to work even when the pin is configured for use...

Asked on 12/03/2020 by crj11

0 answer

Higher than expected voltage in RC low pass filter

I attempted to check the myth about fixing the P0420 error code (Insufficient efficiency of catalytic converter [$3000 part from Toyota]) by inserting a low pass RC filter between an...

Asked on 12/02/2020 by Vladimir Martynenko

1 answer

Op-Amp as an error detector

In the design of an AC servo position flight control surface system, a feedback system compares the output position to...

Asked on 12/02/2020 by BeatriceUK

0 answer

What is the difference between magnetic and primary inductance?

I try to calculate ramp compensation resistor (Rcomp) for flyback SMPS converter design. For this, I examined slope compensation section at page 15 in NCP1252 datasheet by...

Asked on 12/02/2020

1 answer

Ask a Question

Get help from others!

Electrical Engineering : Recent Questions and Answers (Page 61)

Ask a Question