Woodworking Questions, Problems & Solutions : TransWikia.com ~ Page 15

Is working with MDF going to kill me?

MDF is pretty cool stuff. Been around for a fair amount of time now. Stuff is used lots now and days. Dimensionally stable and cost effective for a great deal...

Asked on 03/12/2021

1 answer

Track hardware for hanging plywood panels

I have been looking all over for specific hardware that allows panels to be mounted with the rail hook mounted to a notch. This pdf shows the mounting technique ...

Asked on 03/10/2021 by Fakeer

1 answer

Confusing warning in manual for Dewalt DWS715 miter saw

I just purchased a Dewalt DWS715 miter saw. I have never used one in my life, so naturally I am carefully reading the entire manual (here) first....

Asked on 03/09/2021 by The111

1 answer

Finish for MDF Worktable

I built a thick worktable out of MDF and I'm looking to treat the surface. It's inside permanently but it should survive the occasional Oil/Water spill. Aesthetics don't matter. Can...

Asked on 03/07/2021 by AzulShiva

4 answer

Remove and replace inset wooden handle

I have acquired a Danish vintage teak sideboard with distinctive inset wooden handles that the designer used on a range of pieces. Unfortunately, one of the handles has been damaged...

Asked on 03/07/2021 by Daniel K

4 answer

Levelling off a surface for veneer

I've been making a pretty basic case from plywood and would like to apply some veneer. Unfortunately, one surface needs levelling out because the plywood was a tiny bit...

Asked on 03/04/2021

4 answer

Miter saw slightly hits plastic kerf when cutting at 45°

I got my first miter saw yesterday and have been getting familiar with using it. I was going to do a 45° miter cut when I realized that the blade...

Asked on 03/01/2021

2 answer

Using a 5/8 dado stack on a "30mm" arbor

Background I would like to buy a dado stack, but 30mm is hard to come buy due to laws forbidding selling them in Europe. Using them for personal use is...

Asked on 02/28/2021 by ryanjdillon

2 answer

Good wood(s) for making kitchen utensils?

I was asking a question on the cooking SE site about best utensils for cleaning and scraping pans w/o damaging them (particularly nonmental utensils) and realized that I probably have...

Asked on 02/26/2021

2 answer

How do I mitigate this tear-out, ideally with hand-plane and scraper?

I have a rough-sawn plank of ash that I'm trying to finish using only hand tools (and no abrasives if possible). I think the board is flat-sawn, and you can...

Asked on 02/25/2021

1 answer

Ask a Question

Get help from others!

Woodworking : Recent Questions and Answers (Page 15)

Ask a Question