Find answers to your questions about 3D Printing or help others by answering their 3D Printing questions.
I've just installed two TMC2208 drivers on my RAMPS board. I followed a very good step by step tutorial and after some issues, I got it nearly to work. One...
Asked on 08/26/2021 by Felix Hauser
2 answerI've recently purchased an Ender 3 and have had great success with some Cura settings found on a YouTube Tutorial at 0.2 mm resolution. So then I noticed that there were...
Asked on 08/26/2021 by Calvin
2 answerThe first layer is very patchy indeed. I've calibrated the build plate pretty accurately but even if it was a badly calibrated build plate I don't think it would...
Asked on 08/26/2021 by BanksySan
3 answerSo according to E3D customer service, the V6 is designed to have higher back pressure than the MK8. This leads to underextrusion with PLA and all kinds of problems unless...
Asked on 08/26/2021 by cds333
1 answerI'm printing on an Ender 5 with the default flex/magnetic build surface.I read that PLA and PETG may sometimes be printed without any bed heating at all and also...
Asked on 08/26/2021
5 answerReally need some help. Let me run you through as much as possible.I have a Replicator 2x. I've owned this for around 2 weeks now (used). after some teething...
Asked on 08/26/2021
1 answerWhy does my 3 mm PLA filament always snap near the spool some time (usually a few hours) after a print has finished? I have had it snap mid print but...
Asked on 08/26/2021 by oliver602
3 answerI have a Robo R1+ which uses the nozzle contacting the glass print bed to level the printer. When the print head strikes the bed the Z-min endstops open signaling...
Asked on 08/26/2021 by henradrie
1 answerA part I've printed (on a Monoprice Maker Select V2, sliced with Cura) has a small peg on it, which is an unsupported overhanging section of the...
Asked on 08/26/2021
2 answerI use an Ender 3, with cheap Amazon "Eryone PLA", which states a range from 190-220 °C, 1.75 mm dia. I have had this for about a year. I use the rough...
Asked on 08/26/2021 by Deep
4 answerGet help from others!
Recent Questions
Recent Answers
© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP