Improving my circuit : jump crossing, block layout

I drew a circuit that works, but there are a few small errors that I can’t fix:

documentclass[border=1mm]{standalone}
usepackage[european, straightvoltages]{circuitikz}
usetikzlibrary{babel}

begin{document}
begin{circuitikz}
draw (0,0) node[en amp](aop1){AO1};
draw (aop1.+) 
    to[short] ++(0,-2) node[ground](GND){};
draw (aop1.-) 
    --++(0,1.5) coordinate (in-1) 
    --++(-2,0)  node[npn, photo, anchor=E](photo){} ;
draw (photo.C) 
    --++(-2,0) coordinate (pile) 
    to[battery2] (pile|-GND);
draw (in-1) 
    to [vR, mirror] (in-1 -|aop1.out) 
    to[short] (aop1.out);
draw (aop1.out)  
    --++(1,0) coordinate (out1) 
    to[R] ++(2,0) coordinate (in-2)  
    --++(0.5,0) node[en amp, anchor=-](aop2){AO2};
draw (photo.C) 
    --(photo.C-|out1) coordinate (jump);
node at (aop1.out-|jump) [jump crossing, rotate=90](J){};
draw (jump)
    -- (J.east);
draw (J.west)
    to[pR, n=curseur] (jump|-GND)
    to [short] (jump|-GND) ;
draw (in-2) 
    --(in-2|-curseur.wiper) coordinate(ao2r) 
    to[R] (ao2r-|curseur.wiper) 
    to[short] (curseur.wiper);
draw (aop2.+)
    to[short] (aop2.+|-GND);
draw (in-2)
    --++(0,1.5) coordinate(RC)
    to [R] (RC -|aop2.out);
draw (RC)
    --++(0,1) coordinate (C) 
    to[C] (C-|aop2.out)
    to[short] (aop2.out);
path (aop2.center) ++(2,0) coordinate (in-3) ++(1,0) node[en amp, anchor=-](aop3){};
draw (aop2.out)
    -| (aop3.-);
draw (jump)
    --(jump-|in-3) coordinate (jump2);
node at (aop2.out-|jump2) [jump crossing, rotate=90](J2){};
draw (jump2)
    -- (J2.east);
draw (J2.west)
    to[pR, n=curseur2] (jump2|-GND)
    to [short] (jump2|-GND) ;
draw (aop3.+)
    -|(curseur2.wiper);
draw (aop3.out) 
    to[R] ++(3,0) coordinate (ledR)
    to[leDo] (ledR|-GND);
draw (GND)
    to[short] (GND-|ledR);
draw (GND)
    to[short] (GND-|pile);
end{circuitikz} 
end{document}

• jump crossing : I have drawn them vertically using node at (aop1.out-|jump) [jump crossing, rotate=90](J){}; but there is still a slight horizontal line: how do I remove it?

thank you for the time spent helping me improve my code.