Raspberry Pi Asked by PotatoBox on February 10, 2021
As a part of my PoC project, I’m using single 5050 LED made by Adafruit. I wired it like this (LED – RPi):
SPI is, as far as I’m concerned, is enabled – I’ve done it using raspi-config
and also added required line in /boot/config.txt
manually (I’m talking bout param=spi=on
)
Output of lsmod | grep spi*
command:
spidev 16384 0
spi_bcm2835 16384 0
And ls -la /dev/spi*
:
crw-rw---- 1 root spi 153, 0 Jul 29 19:17 /dev/spidev0.0
crw-rw---- 1 root spi 153, 1 Jul 29 19:17 /dev/spidev0.1
To try out my setup, I’ve launched python interpreter and wrote:
import spidev
spi = spidev.SpiDev()
spi.open(0, 1)
resp = spi.xfer([0x00, 0x00, 0x00, 0x00])
resp = spi.xfer([0xFF, 0xFF, 0xFF, 0xFF])
And nothing happened. What’s important, I want to achieve my goal using Python. SpiDev module was installed at the time of the trials. For now, I’m only interested in simple blink, after this is reached, I can go further with modulation or frequency settings.
you are opened the wrong port.
spi.open(0,0) instead of spi.open(0,1) spi.open(0,1) means you are send data to SPI1 not SPI0.
Because you are send the data for wrong pin. That's why nothing happened.
Answered by Mike on February 10, 2021
At best you may "SEE" MOSI signal AKA "chip select" to change state when SPI device is "selected". You are "looking at " default speed of probably 100kHz which is hardly observable by human eye. You MAY be able to slow down the SPI data transfer by programming for minimal clock speed.
Answered by Jan Hus on February 10, 2021
Get help from others!
Recent Answers
Recent Questions
© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP