Network Engineering Asked by CUPA on January 3, 2021
This is just a quick question I am wondering out of curiosity.
When I set up a network in packet tracer, why does “show IP route” show the network address (example: 199.120.5.64/27) and not the IP address assigned to the end device (example: 199.120.5.66) ?
It’s probably not important, but I just want to understand how it works.
show ip route
command shows the static routing assigned manually
If you do show ip int brief
or show ip interface brief
it will show to ip assigned to a the interfaces on that router.
Correct answer by sgt on January 3, 2021
Router(config)# sh ip route
This command refect existing route entries in devices and directly connected networks (L3 gateways) . It will show 199.120.5.64/27 subnet instead of assign specific ip beacuse routing table reflect entire subnet pointing towards gateways (next hop).
Destination forward packets will destined to destination by taking routing descision based on routing table and forward packet to gateways where route is pointed towards .
Answered by Sagar Uragonda on January 3, 2021
Get help from others!
Recent Answers
Recent Questions
© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP