Motor Vehicle Maintenance & Repair Questions, Problems & Solutions : TransWikia.com ~ Page 40

Will different tread depths hurt my 4 wheel drive?

I have a Ford F150 4x4. The front 2 tires treads measure 12/32, one rear is 6/32 and the other is 10/32. The dealership told me I should...

Asked on 08/15/2021 by NotDan

10 answer

How should I remove this corroded nut without rounding it?

I have a 1982 Porsche 911 and need to remove the heat exchanger on one side. It's held on with three 13mm nuts and 3 barrel nuts. The...

Asked on 08/15/2021

8 answer

Effect of same engine but with slightly less capacity (cc) and hp

There's a vehicle whose engine is 1332cc which produces 94 hp in its home country. It was recently launched in my country with the same engine, but they downsized it...

Asked on 08/15/2021

1 answer

Toyota Sienna 2009 Code P0705

A few months ago, check engine light, VSC, Trac off lights came on. And the Neutral and Drive lights turn on at the same time when in drive (the...

Asked on 08/15/2021

0 answer

Fuel lines: is Nicopp OK for gas?

I need to replace some rotted under-body lines. I'd like to use something easier to bend than old-school steel tubing - in particular, AGS' Nicopp. At...

Asked on 08/15/2021

4 answer

OBD2 Mode 3 No Response

I am communicating with my car OBD2 port with STM32 microcontroller boardand got success to get response to basic PIDs such as Service 01 and 02 and even got...

Asked on 08/15/2021 by A.Kumar

0 answer

2004 Monte Carlo SS supercharged white smoke coming from engine

2004 Monte Carlo SS supercharged with 145k miles: I just replaced the upper intake manifold and supercharger gaskets...plus the oil pan and transmission oil pan and dipstick gaskets. ...

Asked on 08/15/2021 by Mark Pulley

1 answer

Is it safe to drive Ford Fusion 2006 1.6 tdci with broken power steering pump

My power steering pump has failed on mentioned ford model and steering is harder but drivable. Is it safe to drive around 1000 miles with this issue, since I have...

Asked on 08/14/2021 by user65234

1 answer

How do I remove this bolt to replace my MAF sensor?

I'm trying to replace the MAF sensor in my Mitsubishi 2003 Lancer ES GLi1.8, and it's bolted into a plastic housing that fits the air filter. The bolts are weird,...

Asked on 08/14/2021 by e_i_pi

3 answer

AC compressor clutch snap ring holes covered up by something

I'm trying to get the snap ring out of the AC compressor clutch but the holes on the snap ring are covered up. It seems to come from below the...

Asked on 08/14/2021 by Joel Z.

1 answer

Ask a Question

Get help from others!

Motor Vehicle Maintenance & Repair : Recent Questions and Answers (Page 40)

Ask a Question