Is it all right to clean a car radiator with vinegar and chlorine?

I would not use that solution to clean my radiator. Remember that a radiator itself is primarily made of fairly thin aluminum. The bleach/vinegar could very easily damage the structure and weaken it. A washing machine is made of (in most cases) a steel drum coated with porcelain, or stainless steel, both of which are very sturdy and are made to last a long time through a lot of abuse. Your car radiators only jobs are to maintain internal pressure, keep sealed, and allow the transfer of heat from your coolant.

A much better idea is to utilize one of the many products on the market which will safely clean your radiator for you, such as Gunk, Prestone, or Bar's Stop Leak flushes (there are many more, these are just examples). Following their directions here will save you not only time, but money as well. Using the above cleaning agents may, or may not, have adverse affects, but why chance it when you can utilize a product which is specifically designed to clean your entire cooling system and will not harm it in the process.

'Cleaning' radiators is very much a thing of the past. Modern rads are made of alloys and plastics which are no longer cleaned internally. Introducing any sort of caustic cleaner into your cooling system has the very real ability of destroying seals and gaskets and bearings in the system as well. Introducing products like a leak stopping formula only goes to block the passages of your system, especially the heater matrix. Blocked rad means a new rad.

A big fat NO. I'm a corrosion engineer, trust me you don't have to play with the PH of solution and alter (generally increase) the corrosion rate of your radiator. Corrosion rates can raise up to like your radiator vanishing in 6-8 months.

PH highly influences corrosion of copper that's why the coolant has a inhibitor (chemical specie) that controls the PH according to conditions of pressure, temperature, and PH of fluid. It keeps it in the favor of radiator material, ie: copper, etc.

If you must use household products, the least aggressive I've found is good old baking soda. It's just gritty enough to "sand" off the buildup inside the radiator and, unlike vinegar, when mixed with water, baking soda increases in volume to get into all the voids.

Vinegar is an acid, but is mild acetic acid and typically 5% such. It's perfectly okay to use it alone to remove system rust if you just add a gallon to the system and run the car a short while, like 10-20 mins, including turning on the heat to clean the heater core. The you flush the whole system out with clean water, until it runs clear, and then you are ready to add new coolant/water mix, or the 50-50 stuff. You can also use vinegar to soak overnight in your plastic coolant overflow tank if disconnected from radiator, then drain it out, flush with clear water as needed, then reconnect and add some coolant to it. Use the 150K miles type of coolant which probably will really last only half that. make sure you get the right kind for your car, like Toyota and Asian cars vs Other makes, etc. May not seem important, but it is.

i used vinegar; i left it in too long though, and the rust was eaten away from the welsh plugs too!! now i need to get the engine out to change a hidden back welsh plug. the sludge is gone though, and radiator cleaned.

Paddy Croukamp.

Modern aluminium rads will have rust buildup that plug the rad upp, vinegar doesn't work, what you need to do is buy something like Tremans X-rost and take the radiator out plug the holes and fill it up with X-rost, let it be there for 48 hours and then clean it with water, will be like new inside.

I am chemical cleaning engr. Pls. do not use vinegar to your car radiator because it is normally made of aluminum it will severely attack the material. With Citric acid is not also advisable but then possible to use under the condition that you know what to do, like the temperature during the cleaning and time of exposure, do not expose to more than an hour at elevated temperature...citric acid is a chelant it takes out rush mainly... soda ash on the other hand used mainly in oil contaminated equipment, in this case for radiator it is not required.

best way is distilled vinegar and run it till it’s hot, then drain and then back flush till it’s clear then add new rad fluid. been doing it for years and never ever ever ever had a problem. every vehicle i ever did it to never had a problem thereafter. ever. vinegar is the cheapest and most effective cleanse. natures motor oil.. old timers drink a cpl tbl spoons a day of organic apple cider vinegar and it helps balance PH, keeps your intestinal track top notch and many other health perks.