TransWikia.com

How can you change a pressed wheel bearing without a hydraulic press?

Motor Vehicle Maintenance & Repair Asked by Jerreck on July 17, 2021

Is there a good way to change a pressed wheel bearing without a hydraulic press?

Clearly it’s better to do it the right way, which I’m doing (well, a mechanic is doing), but I was wondering if a viable alternative would be pressing the bearing in using a C clamp or something.

I found this video of a guy freezing the bearing and heating up the hub then just sliding the bearing in, but that seems like it would compromise the integrity of one or both of those parts.

5 Answers

There are tools available that can do the job without using a press:

enter image description here

There are many more. The overall theme is the C-clamp like stile of pressing the bearing in and out.

There is an old saying, there is a right tool for the job. These or a press is the right tool. There are other ways but you always run the risk of damaging the bearing, knuckle or both.

Correct answer by vini_i on July 17, 2021

Heating a bearing beyond 300 degrees Fahrenheit will likely compromise the bearing by changing the metallurgic structure of the component.

180* is usually adequate, and 250* is a good max to work with. The important thing is to use a rose-bud with a torch (not a regular tip) or an induction heater and heat the component evenly but focus the heat around the key-way if there is one. Remember that the steel expansion rate is about 6 mils/inch dia/100 degree F>

Make sure you have everything in place beforehand, as you will only have a few seconds to install the bearing once it reaches the appropriate temperature. An infrared thermometer will aid greatly in this endeavor.

Answered by Mike on July 17, 2021

use the correct tools or a mechanic is ALWAYS the best answer. In regards to the heating and cooling method mentioned before, one poster stated heating the bearings would likely damage them, well in the videos others have mentioned you DO NOT heat the bearings, heat the KNUCKLE that the bearing goes into... your FREEZE the bearings... i have not tried this method nor would i recommend it if you have a set up like the tundra where your knuckle also houses your upper ball joint... but, if you have no other choice research the method carefully.

Answered by Justin Galens on July 17, 2021

I used to install steel bushings all the time in machinery all the time. We never heated the receiving bore, just submerged the bushings in liquid nitrogen until the boiling stoops. Usually under a minute. They just slide right in and expand when they come back to normal room temp. That being said, I never tried it with a bearing. MAKE SURE TO USE GLOVES AND NEVER REACH INTO LIQUID NITROGEN TO GET THE BEARING/ bushing! Use a coat hanger or similar to retrieve.

Answered by Scott on July 17, 2021

Late answer, but there is no good way to do it yourself. You can heat the knuckle and freeze the bearing overnight as some have mentioned, but it is not ideal and only works sometimes and you need access to a heat source.

Do not use a hammer, you will likely damage the bearing. I do all my own work too, but a pressed bearing is one I pay a shop to do.

Answered by Aashishkebab on July 17, 2021

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP