TransWikia.com

How can I fix a slow indicator on a Honda Hornet?

Motor Vehicle Maintenance & Repair Asked by parsley72 on May 5, 2021

My Honda Hornet 250 right-hand indicator often takes up to 5 seconds to start flashing, especially when it’s cold. The left seems to be fine. When I flick the switch I can hear the bimetallic strip going very fast (several times a second) then it slows down when the indicator starts. The part is shown below – it doesn’t seem possible to get into it to clean the contacts, etc.

Is there anything else I can do? If I buy a new part will this fix the problem or is there a chance it’s something else?

enter image description here

One Answer

There's a chance the relay needs to be replaced. There's a couple steps you could try beforehand though.

  1. Check resistance between all the wires from the light controls to the relay to the light bulb itself. As long as there's zero to very little resistance you know all your wiring is ok.
  2. You can clean the contacts. Use some steel wool and/or sandpaper to clean any contacts that are exposed, fold up some sand paper to clean any contacts that might be hard to get to.
  3. Once they're clean, and if that does the trick, put a little dieletric grease on all the terminals.

If that all fails just replace the relay, as long as they're available they're probably really cheap. I doubt it could be attributed to anything else. Wouldn't be a bad idea to just take a quick look at your bulbs and bulb sockets.

Correct answer by gh0st on May 5, 2021

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP