TransWikia.com
  1. All Categories
  2. Home Improvement

Home Improvement : Recent Questions and Answers (Page 85)

Find answers to your questions about Home Improvement or help others by answering their Home Improvement questions.

Can I replace two 2x4 jack studs with a steel bracket attached to side of adjacent 6x6 king stud?

As part of my kitchen remodel, I want to move my refrigerator into a closet. In order for the refrigerator to fit width-wise, I need to remove two jack...

Asked on 07/21/2021 by Eric Havemann

0 answer

How do I add a filter to the return air vent of my retrofitted forced air system?

I have a 1940 home with a basement and a forced air heat pump system that was added some time in the past decade by the previous owner. The ceiling...

Asked on 07/21/2021 by jakogut

1 answer

Characteristics of this attic and what can I do to make it easier to traverse?

Are these joists or trusses? My confusion is that I am reading spacing between joists of between 18inches and 24...

Asked on 07/21/2021 by Jeff T

2 answer

Is there a proper way to fill an electrical panel?

I'm installing a subpanel and will submite a panel schedule with my permit application. I have never installed a panel before, so I wonder if there is a proper...

Asked on 07/21/2021

1 answer

Ceiling light/fan remote problem

I have a ceiling light/fan controlled by remote only - no light switch or pull cables. Now the remote receiver is broken and the company doesn't make the replacement part...

Asked on 07/21/2021

1 answer

How to stop paneling cracks around air vent

I bought an older home which has some wood paneling that I've been caulking, Spackling, and painting. I've recently had some issues however with an area of the paneling where...

Asked on 07/21/2021 by rrw023

1 answer

Ecobee3 Setup and furnace only has W G R

My existing thermostat has 4 wires (missing C) so I'm attempting to use the Power Extender Kit (PEK) at the furnace control board. Only problem is, I only have 3...

Asked on 07/21/2021

1 answer

Can I utilize unused 30amp circuit for 20amp welder?

I have an unused 30amp circuit from an old dryer with 2x30amp breaker at panel and 10 gauge wire. I read a similar question asked by someone here and very...

Asked on 07/21/2021 by Hemant Surti

2 answer

What could cause two of my receptacles to stop working?

Problem: No power in two receptacles. Note: Both receptacles on same circuit. What I have done:Checked the 15 amps circuit breakers with a volt tester. Each breaker reads 125 volts.Bought...

Asked on 07/21/2021 by user20786

2 answer

Is it a load bearing wall?

Is it a load bearing wall? I do not think so, but want to confirm. There is also a switch on this wall that I want to move to the...

Asked on 07/21/2021 by commandos1985

0 answer

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP