Home Improvement Asked on April 27, 2021
I’ve got some smaller areas I need to fill with drywall in a room, and fortunately I had some pieces from cutting others while staggering. I used them to fill in the gaps, but I didn’t like how they looked as they were butt edges against tapered edges. I took them down and used a fresh sheet to ensure all tapered edges met.
However, I feel like I wasted an entire sheet just to achieve this. Is it fine to have a butt up against a tapered edge?
It depends how fussy you are. A perfect finish is easier if you have the only joints at tapers and corners.
Answered by Jasen on April 27, 2021
What I do with butt edges, which also come about when you're putting in a drywall patch, is to peel off the outer most layer of paper on the drywall about 1" or so back from the edge on both the pieces. Then just apply mud, joint tape, and mud like you would for a taper joint.
If you peel off too much paper, then you're liable to have an edge show where the peeled off section meets the un-touched drywall.
Answered by SteveSh on April 27, 2021
This is a common situation on any large drywall project. You'd handle it the same way you would any butt joint--with a wide taper.
The very talented pros I worked with would taper butt joints at least 16" each way from a butt joint. Do a pre-fill of the lower sheet to get things more level and let that dry. Then apply tape as normal. For the final coats, work outward with a wide knife.
As with all taping work, very little sanding should be necessary. The knife creates the taper and the finish, for the most part.
Answered by isherwood on April 27, 2021
Get help from others!
Recent Answers
Recent Questions
© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP