TransWikia.com

Dishwasher - 3/8 inch 90° elbow leaks. How do I tighten it without overtighting it and it is pointing down?

Home Improvement Asked by Dave C on June 23, 2021

I’ve installed a new dishwasher, but the 3/8 inch 90° elbow leaks.

How do I tighten it without overtightening it and it is pointing down?

I put two wraps of teflon tape and hand tightened it, and tightened with a wrench about 3/4 turn.

Thanks for any advice or tips.enter image description here

3 Answers

Try tightening the elbow more. You don't usually have to worry about over tightening brass on brass, You can torque them pretty good. If the fitting doesn't point down, so be it, it needs to be tight.

Answered by JACK on June 23, 2021

If you can not get that elbow to stop leaking, try RTV silicone on the threads instead of the teflon tape and wait a couple days to use the washer.

Answered by d.george on June 23, 2021

Just redo the ptfe and put more layers - most common error is people skimp on the tape as they think it is expensive, also make it have more layers towards the middle.

PTFE is not Pull Tight (it’s) F... Expensive.

Answered by Solar Mike on June 23, 2021

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP