'Error: table was not found' when running Locate Regions tool using modified raster

Using ArcGIS 10.7 desktop

I want to run the Locate Regions tool on a land use raster (32 bit signed, with values 0 – 95) in order to identify cell groupings representing a certain land area size. When I run this raster the tool returns an output. But I only want to perform the analysis on upper cell values between 70 – 95. So I used the Extract by attribute tool to get a new raster only containing these values.

I get the following error when I input the 70 – 95 value raster:

ERROR 999999: Error executing function.
The table was not found. [VAT_habitat_suitability_70to95]
No spatial reference exists.

I can’t figure out why I get this error. The raster and its table appear to be the same as the original, also 32 bit signed integer and field types are same but just truncated records with the corresponding raster cells. Obviously there is a table and this raster has the same properties, coordinate system, etc.