Engineering Questions, Problems & Solutions : TransWikia.com ~ Page 30

Unable to multiply the part along the same axis as rotate in SolidWorks

I am trying to multiply part with Linera Pattern and have each instance rotated by 180 degrees. Unfortunately, I can't specify the same axis for both rotation and copying. It...

Asked on 06/10/2021

0 answer

Shore durometer type D to brinells

I saw a video where a person was measuring hardness of a material with Shore durometer type D and was comparing it to steel. The screen on durometer showed 96.5...

Asked on 06/09/2021 by RotV

0 answer

How to simplify a truss bridge diagram?

Hello I have this truss structure question. I understand that we need to determine the zero-force members first so that...

Asked on 06/09/2021 by Sobika42

2 answer

Is it possible to use direct air capture technology for CO2 on a non-commercial level?

CO2 is used as fertilizer in aquariums where it's brought into the water with diffusors from compressed form in cylinders. Direct Air Capture machines for CO2 have...

Asked on 06/09/2021

1 answer

Derivation of 2nd order damped rise time

Given the transfer function: $$frac{omega_0}{s^2 + 2omega_0zeta s + omega_0^2}$$ How would you derive the rise time of the system from 0% SS to 100% SS. $$t_r =...

Asked on 06/09/2021

1 answer

Verify assigning of material to all parts in a assembly

is there any provision in SolidWorks to check if all parts in an assembly is assigned material, rather than individually checking each part under the design tree? It becomes tedious...

Asked on 06/09/2021

0 answer

Why is it more convenient to express stress tensor in Material rather than Spatial coordinates?

I was reading chapter introduction about Stress and the author wrote the following about stress tensors: "Since the current configuration of many problems, especially those involving solids, is not known,...

Asked on 06/09/2021 by user134613

0 answer

what kind of welding setup to mig weld high-temp stainless

In my initial foray into welding I am looking at welding some 300-series stainless tube, no thicker than 1/4" and more likely 1/8". I have not yet purchased a...

Asked on 06/08/2021 by WestonM

0 answer

How do I connect multiple water-filled syringes?

I'm trying to connect 4 separate syringes containing water and we need water-tight tubing to prevent water from leaking out of the system. The water would theoretically need to be...

Asked on 06/08/2021

2 answer

MSC Adams: “angular kinetic energy” vs “angular momentum about a center of mass”: which is the most relevant measure of the flywheel's storage?

MSC Adams produces several different measures of a rotating body. In a flywheel, what is the difference between 'angular kinetic energy' (in newton-mm) vs 'angular momentum about the center of...

Asked on 06/08/2021

1 answer

Ask a Question

Get help from others!

Engineering : Recent Questions and Answers (Page 30)

Ask a Question