Engineering Questions, Problems & Solutions : TransWikia.com ~ Page 28

Gear Design - Hunting tooth

Has there ever been any experimental verification of the benefits of designing a gear pair to have a "hunting tooth"? The idea is to even out wear by...

Asked on 06/15/2021 by user9106985

1 answer

Calculating Minimum Pipe Pressure Requirement for an Irrigation System

I am setting up an irrigation system for my ranch and I have a hard time calculating the minimum pipe pressure requirements to reduce cost. I need to know the...

Asked on 06/15/2021 by Ehsan Darrudi

1 answer

Question on fluid flow measurement uncertainty

Say you are trying to measure the liquid flow rate (mass or volume) through a pipe and you want to get the best measurement possible, and you have two flow...

Asked on 06/15/2021 by Diogo

2 answer

What is the name of a half wall with posts on top that divides a space into two?

I am looking for specific terminology around a half wall that acts as a divider to split a space into two separate uses. The top half of this features a...

Asked on 06/15/2021 by FrontEnd

1 answer

Is transverse synonym of lateral?

Longitudinal axis (x) is the axis orthogonal to its lateral directions (y and z), but what is transverse direction? Is transverse just another term for lateral?...

Asked on 06/14/2021

4 answer

Using a thermos flask as a vacuum chamber

I want to create a vacuum chamber (-900 mbar) that can withstand heat (120°C).I thought about using a pressure cooker similar to most DIY vacuum chambers, but then thought...

Asked on 06/13/2021 by adnan

0 answer

How to add comments to solidworks variable file?

When using an external .txt file to define global variables for SolidWorks 2021, can one add comments to this file, and what is the syntax?...

Asked on 06/13/2021 by TheOnlyRealCoder

1 answer

Help in Inverse Laplace Transform in Circuit Analysis

Inverse Laplace Transform $frac{1}{s^2 + sqrt{2}s + 1}$ so what I did it changed the denominator to complete the square...

Asked on 06/13/2021 by EM4

1 answer

Why isn't von Mises criterion valid when compressive and tensile yield stresses differ?

For example here, it is mentioned:The von Mises criterion is NOT a valid yield (failure) criterion for materials with different yield stress valuesin tension and compression.I...

Asked on 06/13/2021

1 answer

Hand thread taps for stainless steel

I'm finding myself doing quite a lot of thread cutting in stainless steel lately, particularly 304 and 316, often these are moderately deep threads ~ 25 mm or so and...

Asked on 06/12/2021 by Chris Johns

3 answer

Ask a Question

Get help from others!

Engineering : Recent Questions and Answers (Page 28)

Ask a Question