TransWikia.com

Configuring UART Port to 115200 on Renesas RX130 using Code Generator

Engineering Asked by Niloy Talukder on August 19, 2020

Does anyone have insights into configuring UART port on Renesas RX130 microcontroller for a bit rate of 115200? I have successfully configured for a 9600, 19200, and 38400. I can read from the MCU and write to the MCU via terminal programs such as tera term. I am using the code generator available through e2Studio IDE.. I am using Serial Communication Interface SCI1, from which I have configured RXD1 / P30 (Pin 18) and TXD1 / P26 (Pin 20). Note P30 is port 3 bit 0 and P26 is port 2 bit 6.

Below is the MCU package configuration view
enter image description here

Below is Code Generator software component configuration view SCI1
enter image description here

Has anyone run into similar issues? Thanks for your help!

Note: I am open to exploring Firmware Integration Tool (FIT) to configure UART ports

Add your own answers!

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP