Does rRNA depletion protocol give higher number of mapped reads in Intronic regions?

Recently, I have downloaded a publicly available dataset, which are 350 tumor samples. I see the following information from the published paper.

They used Ribo Zero Gold and rRNA was depleted. Strand specific data. After aligning the data I did some alignment quality check with Qualimap RNA-Seq QC tool. I visualised the bam files in IGV. Alignment is good. For all samples 90% alignment rate was seen. I observed that in all samples Higher percentage of mapped reads were originating in Intronic regions. Followed by Exonic and intergenic regions.

I have seen a post here Reads mapped to exonic, intronic and intergenic regions where they say high intronic reads could be because of contamination. I googled about higher reads in intronic regions and found some papers Evaluation of two main RNA-seq approaches for gene quantification in clinical RNA sequencing: polyA+ selection versus rRNA depletion and some other links RIBO-DEPLETION IN RNA-SEQ – WHICH RIBOSOMAL RNA DEPLETION METHOD WORKS BEST? in which they said Greater intronic reads were with rRNA depletion protocol.

And even in this RNA-SEQ tutorial, it is mentioned that – A higher intronic mapping rate is expected for rRNA removal compared to polyA selection.

So, my question:

I am working with lncRNAs. So, I’m using the samples prepared with rRNA depletion protocol. Is this higher intronic rate is common in rRNA depleted dataset or do I have to check anything else to proceed further with these samples?