Bicycles Questions, Problems & Solutions : TransWikia.com ~ Page 170

Clunking noise only when pedaling at higher RPM not low RPM. Video of Issue linked

Bicycle Type: Gary Fisher Marlin Mountain Bike with 3x9 drive train. Issue Description: When pedaling, there's a clunking noise emanating from what sounds like the cassette & hub interface but...

Asked on 02/24/2021 by J99

1 answer

What tool do I need to remove this Joytech freehub?

I have tried 10mm allen: too small, spins freely, with very little grip. Hub brand: Joytech On the outer side it has 9 ball bearings. Video showing right/drive side:Video...

Asked on 02/24/2021

4 answer

Fasted training - is it worth it? Is it different when the focus is endurance?

One thing I notice riding with an endurance-focussed club is that I need more, and more frequent, feeding than many of the more experienced riders. As I start to think...

Asked on 02/24/2021

3 answer

Are all DUB cranks compatible?

I have a dub crankset with arm length 175 (https://www.sram.com/en/truvativ/models/fc-styl-7k-b1) I want to change the crank arm length to 167.5 There's no 167.5 crank arm for SRAM...

Asked on 02/24/2021

1 answer

How To Prevent Holes Around The Inner-tube Valve?

In the last two months I have experienced something new: three inner-tubes (700X25) have popped with holes immediately around the valve and on the same side of the tube as...

Asked on 02/24/2021

8 answer

How do I adjust my child's bike shown in this video to improve fit and comfort?

TimelineProvided because I learnt a lot in the processMy 5yo daughter has started growing out of her Apollo Petal with 14" wheels and an upright position typical of a child...

Asked on 02/24/2021

1 answer

Are bikes with sloping top tubes lighter than bikes with horizontal top tubes?

For many years bicycles nearly universally had horizontal top tubes, but that has changed: now most bicycles have "compact" geometry, with top tubes that slope downwards from front to back....

Asked on 02/23/2021 by rclocher3

1 answer

Is it really necessary to physically cross (interlace) the spokes on traditional wheel lacing?

Recently I had to replace a hub on the front wheel of my workhorse bike. That meant unlace it and lace it again. Since the hubs were identical, I used...

Asked on 02/23/2021

14 answer

Tire went flat, then held air?

During a recent ride my tire went flat on my tri bike. I was about to change the tube but thought I'd just put some air in the flat tire...

Asked on 02/23/2021

1 answer

Grx 10 speed problem

I have a new 10 speed grx group set. The right hand shifter have only 9 gear. I check the problem is in lever,i felt in high gear it was...

Asked on 02/23/2021

1 answer

Ask a Question

Get help from others!

Bicycles : Recent Questions and Answers (Page 170)

Ask a Question