Disabling 10NES Chip

Question

I've got a pair of classic NES consoles; one in near-pristine condition and the other that shows a bit more exterior wear, but still functions just fine.  Since I still enjoy throwing games on the original console from time to time, I was thinking about disabling the 10NES chip in the latter unit to increase its overall reliability.

The question here is twofold:

Is this a simple task (e.g. just cut a pin with a pair of wire cutters), or is it more involved (e.g. time to break out the soldering iron)?
Will this modification have any negative effects from a usability standpoint?

agent86 · Accepted Answer

The 10NES chip can be effectively disabled by cutting pin 4 on the chip.  (The pins are numbered starting with the black dot as 1, and then continuing down the same side of the chip as the dot).

I did this to my old NES and it worked fine.  However, any hardware modification can be somewhat risky, so your mileage may vary.

There's a picture of the chip and the pin to cut on this wiki or there's also this YouTube video that goes step by step.

You can tell if the 10NES chip is disabled because the 10NES chip will reset the console over and over again if a valid cartridge is not inserted.  If your power light doesn't blink constantly anymore when the console is empty, then you did it right :)

As far as I'm aware, there's no downside to removing the 10NES functionality.  In fact, later NES models that were compatible with the same cartridges did not include it.

For a more in-depth look at the 10NES chip, and a perhaps more in-depth way of disabling it (by routing pin 4 to ground instead), there's this guide.

However, some NES reliability issues are related to the funky 72-pin connector on the NES-001, rather than the 10NES chip directly.  You may also have to clean, refurbish, or replace this connector to improve the console reliability, depending on the particular issues your hardware has.

Ben · Answer

This is actually really easy to do. I have zero experience working with electronics pretty much and was able to easily do it with this tutorial. The only thing I'd add to is it the cartridge tray is a lot easier to put back when you realize there is a tab on the bottom front of it that's suppose to slip under the motherboard and bottom RF shield.
I'd also add the Chip it's self is really tiny so reading glasses will make this task much easier,(it did for me anyway). I used a tiny flat head screwdriver, some patience and as little force as necessary (due to the capacitors right next to it), to pull the pin right out of the chip and when I hooked it back up to the TV it still worked.

Disabling 10NES Chip

2 Answers

Add your own answers!

Ask a Question