Home Improvement Questions, Problems & Solutions : TransWikia.com ~ Page 68

Repurposing outdoor LED security floodlights for an indoor sconce

I am trying to create a very bright wall sconce using two LED security floodlights. I have disassembled the floodlights so I could remove them from the very bulky, heavy...

Asked on 08/05/2021 by Charlie Clements

1 answer

How should I hang joists that are supposed to be doubled, but that will sit over the joining of two boards?

I need to hang a 22' ledger board, but I can only get treated boards up to 20' in length. The deck plan calls for a doubled joist at...

Asked on 08/05/2021

1 answer

How to install a Wemo Three-way light switch in this configuration?

I currently have this configuration in my home and I would like to replace the left switch with a wemo three-way Smart light switch. I'm not able to find any...

Asked on 08/05/2021 by xa1200

3 answer

Installing a y pipe

I had sweating ducts.i pulled the drywall down and wrapped all the ductwork.the main stack, two 4 inch ducts and two 6 inch ducts in my dining room and into...

Asked on 08/05/2021

1 answer

AC shuts but fan keeps running

After running for some time, AC shuts but blower keeps running.NEST says no power to Rh line.Have a Rheem Criterion, have separate breakers for AC and Fan. Twice,...

Asked on 08/05/2021 by San.D

4 answer

How do I remove this metal grating-type thing from a coffee table?

I want to remove this lower part of my coffee table so I can sit down and put my legs under the table.How do I remove it cleanly?(I'm...

Asked on 08/05/2021 by Larry Wood

2 answer

Am I installing the drain saddle for a single bowl sink in the right location?

I’m trying to install a drain saddle for my reverse osmosis system and only have a single bowl and the instructions are written for a dual sink. Is B the...

Asked on 08/05/2021

0 answer

Water heater pilot lights but burner doesn't ignite

My hot water tank heater won't work. I held the knob thing down, clicked the ignite button, and the flame came right on, but the status light won't flash and...

Asked on 08/05/2021 by user46113

3 answer

Can the blanket Insulation in my basement be left in place when refinishing?

I'm thinking about finishing my basement. It currently has the blanket insulation that the builder installed when we built the house last year. I'm unfamiliar with this product. Is it...

Asked on 08/05/2021 by Jared Christensen

5 answer

Cutting powder coated steel - how do I prevent rust?

We have a series of powder-coated electrical cupboards that need to be cut open to install recessed components. The exact product description can be found on the...

Asked on 08/05/2021 by klonq

3 answer

Ask a Question

Get help from others!

Home Improvement : Recent Questions and Answers (Page 68)

Ask a Question