Home Improvement Questions, Problems & Solutions : TransWikia.com ~ Page 329

How would I connect multiple ground wires in this case (replacing ceiling pendant lights)?

We have this new pendant light where there are WHITE (neutral) - BLACK (live) - GREEN (grounds) wires from the pendant and bare copper wire already attached to and coming...

Asked on 12/24/2020 by YYL

4 answer

Nearly all basement lights dependent on switch at top of stairs

I went to a house this evening for a showing and encountered a situation involving the basement lighting that I'm almost certain violates at least one part of the NEC....

Asked on 12/24/2020 by Logarr

3 answer

12' sliding door frame shimmed up against header and sagging at point where shimmed

I have a sliding door with glass panels on each side, spanning a width of 12 feet. The door has been sagging in the middle. It slides easily at...

Asked on 12/24/2020

2 answer

Coil of the cooking heater overheats and burn out very often?

The coil usually burn at the points circled in red near the power connection. We have 240V electric supply.which the wire support it says.we don't have switch for ON-OFF for...

Asked on 12/24/2020

1 answer

Is 12 cu. in. LB PVC Conduit large enough to splice 12/2 run?

I am running a 20A circuit to the garage and using a LB conduit at a point where my run comes out of the basement and goes underground. I want...

Asked on 12/24/2020 by ssm

1 answer

Necessary to tape ceiling-wall joint if installing moulding?

Just got my drywall up in a room that I will be installing crown moulding in. Is taping the joints where the ceiling meets the wall necessary if its just...

Asked on 12/24/2020

1 answer

Drywall texture used?

Can someone please help me identify the texture in this picture? I’ve been patching a few holes around the house and cannot get the texture to match no matter what...

Asked on 12/24/2020 by Terah B

1 answer

Insulating stand-alone studio (shed)

I am looking for advice on insulating a stand-alone studio... I want to keep the "exposed" studs look (similar to board & batten). I plan on installing rigid insulation between...

Asked on 12/24/2020 by Ken A

0 answer

Problems w/ Nest

I've got a common problem but I can't seem to find the...

Asked on 12/24/2020 by Ka1275

0 answer

60 amp Fuse box as junction box for 150a panel

Electrician in PA wants to use old 60amp FEDERAL fuse box panel (which happens to be in bathroom wall, less than 3 feet from sink and shower) as junction Box...

Asked on 12/24/2020 by Justjen

3 answer

Ask a Question

Get help from others!

Home Improvement : Recent Questions and Answers (Page 329)

Ask a Question