TransWikia.com
  1. All Categories
  2. Home Improvement

Home Improvement : Recent Questions and Answers (Page 104)

Find answers to your questions about Home Improvement or help others by answering their Home Improvement questions.

How to repair a sheared threaded hole for grub?

What would be a sufficiently robust way to rethread a hole for a grub which needs to be very tightly fastened? I have a tilt and slide patio door. The...

Asked on 07/03/2021 by Flash_Steel

1 answer

What are my dimmer options in this switch configuration?

I have a setup in my basement where there is a 4-way switch setup, but none of it is run using 3-wire. I've seen the term "California 3-way", so...

Asked on 07/03/2021

1 answer

Is it a problem that my furnace filter is loose in its slot?

When I bought my home, my furnace had a 16x20x1 nominal-size filter installed, and that's what I've been buying for replacements. This size doesn't fit the opening very well; there...

Asked on 07/03/2021

3 answer

Having trouble removing tap aerator/regulator

How do I remove my bath mixer tap regulator? Its quite thin compared to all the videos and photos ive seen of people removing theirs. I bought new female+male aerators...

Asked on 07/02/2021 by Del32

2 answer

Left/Right Sliding Window

I have a left/right sliding window in kitchen as pictured below. I want to add a standard indoor window fan positioned at the top. This fan has screw holes on...

Asked on 07/02/2021

0 answer

HVAC air flow question

What is an appropriate distance between a finished floor and bottom of an interior door to make sure there is adequate HVAC air flow when door is closed.Several sites...

Asked on 07/02/2021

1 answer

Make-up Air intake tripping smoke alarm

I have the MUA intake vent on the patio of my condo, located on the ground floor, so the patio has a ceiling. Frequently when I barbecue, smoke rises...

Asked on 07/02/2021 by Domi B

1 answer

Which grade of PVC piping do I need in order to sustain a 1,000Pa vacuum?

I'm rigging a proof of concept DIY machine, in which the internal pressure will need to be at most 1/50th of atmospheric pressure. For a safety margin, I want the...

Asked on 07/02/2021

1 answer

Gas Pressure Regulator

I am currently in the process of having my gas service upgraded to a 2psi system. My plumber is about to rough in and install all the piping, along with...

Asked on 07/02/2021 by Mg5487

0 answer

adding more insulation on garage side of wall, and held in place with plastic sheeting has resulted in a moisture issue

I am closing the ceiling of my garage, and wanted to do a few things before that was completed. It's a 2 story house, and there is a shared...

Asked on 07/02/2021 by dnix

2 answer

Ask a Question

Get help from others!

© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP