Hanging hooks in a weak wall

Question

I used to have some (guitar) hooks which were screwed into a brick wall, but 2/3 of them have fallen out. My only guess is that (since they are all at the same vertical height) they all went into a line of mortar rather than brick? Anyway would like to put them back up, and for them to stay up this time.
I don't think the original holes are salvageable, they've become quite enlarged, and unhelpfully filled by yours truly.
My plan is to screw and silicone adhesive a wooden batten to the wall and then screw the hooks into the wood. I'm thinking sand and varnish a 18x69mm spruce batten, use 4 chunky screws and wall plugs and a healthy dose of silicone adhesive to hold the batten to the wall, and finally some small screws to hold the hooks to the batten (the holes in the hooks are small, and the wood is thin, so the screws have to be both small and short).
I just want to check that I'm not missing anything before I permanently butcher my wall, and ask whether it's okay for the screws holding the hooks to the batten to go all the way through the wood, because the screws that came with it are just slightly too long. 3 guitars would weigh about 10kg in total for reference.

Jeff Wheeler · Answer

I think you have a nice project idea.  The type of masonry anchors/screws you choose will be important.  I recommend Tapcon screws long enough to use a washer, penetrate the wood/cleat, and go 1.5" into the wall.  So that'll probably be 3" in total length.  Get the recommended masonry drill bit when you purchase the screws; and install them approximately as described, below:

mark the desired location of mounting cleat on the wall

mark the desired screw/anchor locations on the cleat

drill holes in the cleat

place the cleat against the wall again, and use the drill holes to transfer marks to the brick wall (spray paint with a thin nozzle works well)

pre-drill holes in the brick using the recommended masonry drill bit; this will be slightly thinner than the tapcon anchors.  A hammer-drill helps a lot here.  The needed hole will be around 1/4" deeper than the fastener, so for a 1.5" fastener installation depth, hole depth 1.75".  The instructions that come with the tapcon fasteners will indicate this, too.

hold the cleat back up to the wall.

install washers and tapcon anchors through the cleat and into the wall.  An impact driver with the correct hex bit will help.

The trick with this is if you don't already own a hammer-drill and impact driver (and bits) you may need to rent or borrow them, or the job will be more difficult.  That's half the reason for paying handy-men is if you don't want to accumulate expensive tools that you may not use often.

John Canon · Answer

Three individual vertical battens about 4 inches wide by 8 inches tall, each with a top and bottom screw. Cut each shape with a guitar motif, maybe echoing the outline of a guitar head. Mount the clamp two-thirds up the batten, to handle the gravity forces, and for a better look.
A horizontal batten would look too much like a rack of coat hooks..

Hanging hooks in a weak wall

2 Answers

Add your own answers!

Ask a Question