Amateur Radio Asked by user14157 on December 20, 2021
I got 2 Baofeng 888s off Amazon and reprogrammed them to the 16 legal channels (for unlicensed use) in Germany, up from 446.00625 MHz in 12.5 kHz steps.
I used both CHIRP and a software called ZT-V68 to make sure they are identically programmed. So both in CHIRP and in ZT-V68, when I download the settings from radio one and then compare them to the downloaded settings from radio two (making sure that it is actually downloading and showing me the new data from the other radio) — these software data files look identical. All the settings are the same. I disabled the “scrambler” in everywhere, and set all channels to “low”.
But the radios are not communicating with each other. Why on earth can that be?
Try putting power to high. I think low is not supported.
Answered by Antony on December 20, 2021
When you want to load data to baofeng I think you must adjust both channel buttons (for two devices) on the same (first device on ch.1 and connect to pc and next device on ch.1).
Answered by RKHMRT on December 20, 2021
One other setting for each channel that may be giving you problems is Duplex/Simplex. Make certain it is set to Simplex or equivalently "no offset". This feature, when turned on, causes that channel to transmit and receive on different frequencies - typically for using the radio with a repeater.
Viel Glück!
Answered by Glenn W9IQ on December 20, 2021
Get help from others!
Recent Questions
Recent Answers
© 2024 TransWikia.com. All rights reserved. Sites we Love: PCI Database, UKBizDB, Menu Kuliner, Sharing RPP