Resume print but no extrusion

Had a print stop about 20 % through and read through some old questions (3+ years) so I’m posting again. Apologies if it’s in here some where…

Found the layer to restart, deleted everything from layer 0 to layer 77 (in my case)

The set the E value to the value in layer 76, but still no extrusion. Using Ultimaker Cura. I can dump this but really want to know for future issues with larger prints…

EDITED AFTER ANOTHER ATTEMPT: (Same effect)
Sorry, I’m at a loss
also made change to G92 code subtracting 5

Here is the start sequence:

;FLAVOR:Marlin
;TIME:41644
;Filament used: 21.0489m
;Layer height: 0.2
;MINX:29.678
;MINY:92.227
;MINZ:0.2
;MAXX:198.806
;MAXY:194.503
;MAXZ:65.6
;Generated with Cura_SteamEngine 4.6.1
M140 S50
M105
M190 S50
M104 S200
M105
M109 S200
M82 ;absolute extrusion mode
; Ender 3 Custom Start G-code
G92 E0 ; Reset Extruder
G28 ; Home all axes
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X0.1 Y20 Z0.3 F5000.0 ; Move to start position
G1 X0.1 Y200.0 Z0.3 F1500.0 E15 ; Draw the first line
G1 X0.4 Y200.0 Z0.3 F5000.0 ; Move to side a little
G1 X0.4 Y20 Z0.3 F1500.0 E30 ; Draw the second line
G92 E0 ; Reset Extruder
G1 Z2.0 F3000 ; Move Z Axis up little to prevent scratching of Heat Bed
G1 X5 Y20 Z0.3 F5000.0 ; Move over to prevent blob squish
G92 E0
G92 E0
G1 F2700 E-5
;LAYER_COUNT:328
G0 Z15.6

G92 E1744.14148
;was G92E1749.14148

;TIME_ELAPSED:19808.769206
;LAYER:77
;TYPE:SUPPORT
G1 F2700 E1754.14148
G1 F1500 X73.481 Y110.942 E1754.14217
G1 X74.078 Y110.968 E1754.16204
G1 X74.527 Y110.792 E1754.17808
G1 X75.311 Y110.007 E1754.21498